DSE5110

DSE5110&DSE5120
AUTO START&AUTO MAINS FAILURE CONTROL MODULES
The DSE5110 is an Automatic
Start ControlModule designed to
automatically start and stop diesel
and gas generating sets that
include non electronic engines.
The module also provides
excellent engine monitoring and
protection features.
The module has the ability to
monitor under speed, over speed,
charge failure, emergency stop,
low oil pressure, high engine
temperature, fail to start, fail to
stop and loss of the speed sensing
signal. The module displays fault
conditions on the LCD display and
via the LED indicators on the front.
The DSE5120 is an Automatic
Mains Failure ControlModule and
includes all the features of the
DSE5110 plus the ability tomonitor
a mains (utility) supply. Upon
detection of a mains (utility) failure
the module automatically starts
the generating set. Once themains
power has been restored it instructs
the generating set to stop.
FEATURES
• Automatic start
• Automatic mains (utility) failure
detection (DSE5120 only)
• Automatic load transfer
• Configurable inputs
• Configurable outputs
• Configurable alarms & timers
• Digital inputs
• Analogue inputs
• Back-lit character LCD display
• Engine protection
• Front panel mounting
• Icon based fault diagnostics
• PC configurable
• Front panel programming
• Remote monitoring
• LCD alarm indication
• LED alarm indication
BENEFITS
• In-built engine diagnostics
removes the requirement for
service equipment
• License free PC software
• Modules help to improve the life
cycle of engine starter motors
• On-site module configuration
• User-friendly set-up and button
layout
OPERATION
The modules are operated using
the front STOP, AUTO and MANUAL
push buttons. The DSE5120 also
includes a TEST button. An
additional push button on both
modules allows the user to scroll
through the LCD instrumentation
display.
CONFIGURATION
The modules can be configured
using the front panel buttons or the
DSE810 interface and PC software.
INPUTS & OUTPUTS
Analogue inputs are provided for oil pressure and engine temperature.
These connect to conventional engine mounted resistive sender units to
provide accurate monitoring and protection facilities. The modules can also
be configured to interface with digital switch type inputs for low oil pressure
and high engine temperature shutdowns.
Relay outputs are provided for fuel solenoid output, start output and three
additional configurable outputs. A range of different functions, conditions or
alarms can be selected for the three configurable relay outputs. These outputs
are fed from the permanent plant supply.
DSE5120 only
Dedicated outputs are provided for the control of both the mains (utility) and
generator switching devices. This feature combined with the inbuilt incoming
mains (utility) supply sensing, removes the requirement for expensive external
devices.
INSTRUMENTATION
The modules provide advanced metering facilities, displaying the information
on the LCD display. The information can be accessed using the display scroll
push buttons located next to the LCD display.
Generator Volts L1-N, L2-N, L3-N
Generator Volts L1-L2, L2-L3, L3-L1
Generator Amps L1,L2, L3
Engine Speed RPM
Generator Frequency Hz
Engine Oil Pressure (PSI & Bar)
Engine Temperature (oC & oF)
Plant Battery Volts
Engine Run Hours